Dantex Air Conditioner Error Codes

E1 - an error occurred in the non-volatile memory;

 

E2 - there was a transition error through zero;

 

E3 - there is no control over the speed of rotation of the indoor unit fan;

 

Е4 - the mode of protection against the raised level of pressure works;

 

E5 - there is no contact with the open temperature sensor control;

 

E6 - there is no contact with the control of the temperature sensor of the evaporator.

 

Chillers Dantex (DN)

 

E0 - an error occurred in the operation of the water meter;

 

E1 - an error occurred while connecting the phases;

 

E2 - a communication error has occurred;

 

E3 - a water temperature sensor error occurred at the output;

 

E4 - a water temperature sensor error occurred at the outlet from

Shell-and-tube heat exchanger;

 

E5 - error in the operation of capacitor A;

 

E6 - error in the operation of capacitor B;

 

E7 - an error occurred in the outdoor temperature sensor;

 

E8 - an error occurred in the temperature sensor of the charge air;

 

E9 - an error occurred in the flowmeter;

 

EA - the main unit revealed a decrease in the number of additional blocks;

 

EB - malfunctions in the anti-frost protection system;

 

EU - malfunction of the drive controller;

 

ED - there was an error in the control and communication system between the blocks;

 

Ed - activation of electrical protection;

 

EE - there was a communication error between the microprocessor and the control panel;

 

EF - a water temperature sensor error occurred at the inlet;

 

PO - overheating or increased pressure;

 

P1 - the pressure in system A has decreased;

 

P2 - increased pressure or overheated air in system B;

P3 - the pressure in the system has decreased;

 

P4 - there was an overcurrent in the system A;

 

P5 - current overload occurred in system B;

 

P6 - the pressure in the condenser of system A increased;

 

P7 - the pressure in the condenser of system B increased;

 

P8 - malfunction of the compressor discharge temperature sensor in system A;

 

Рb - protection against frost;

 

PE - the temperature in the heat exchanger has decreased;

 

F1 - errors in the work of permanent memory;

 

F2 - errors in the operation of wired controllers.