DeLONGHI Coffee Machine Troubleshooting

DeLonghi Coffee Machines Errors

 

FILL TANK

 

The water tank is empty or not properly inserted.

 

The tank is dirty or covered with scum.

 

Fill the water tank and push it in until it stops.

 

Rinse the tank or clean it of scale.

 

GROUND TOO FINE / ADJUST MILLAND

 

With the coarse grinding, adjust the grinding and install the water supply unit, then press "OK"

 

Coffee from the bottling group flows slowly.

 

The coffee machine does not make coffee.

 

Turn the grinding handle counter-clockwise towards the number 7 (during the grinder operation).

 

Install the hot water supply unit, press the "TEAK" button and for a few seconds drain the water through it until it turns off. If it does not help, contact the service center.

 

EMPTY GROUNDS CONTAINER

 

Clean the cassette for the ground

 

The container for the coffee grounds is full or not installed.

 

Clean the ground container and replace it.

 

INSERT GROUNDS CONTAINER

 

Insert the cassette for the ground

 

After cleaning, a container for gathering the thick is not inserted.

 

Open the maintenance door and insert the container to the ground.

 

ADD PRE-GROUND COFFEE

 

Fill the ground coffee

 

With the selected mode, the ground coffee is not poured into the funnel.

 

Pour 1-2 scoops of ground coffee into the funnel.

 

FILL BEANS CONTAINER

 

Fill the bean container

 

Coffee beans are finished.

 

If the coffee grinder is very noisy, it means that a small object that was with the grains blocked it.

 

Fill the bean container.

 

Contact the service center.

 

DESCALE

 

Descaling

 

Indicates that a scum has formed in the coffee machine.

 

As soon as possible, perform a descaling program.

 

PRESS / SET

 

Press "SET"

 

The brewing unit may not have been inserted into the coffee machine after cleaning.

 

Leave the door closed for maintenance, and do not insert the brewing unit into the coffee machine and follow the instructions that appear on the display of the coffee machine.

 

CLOSE DOOR

 

Close the door

 

The service door is open.

 

If the door can not be closed, check that the brewing unit is correctly inserted. If it does not help, contact the CoffeeService service center.

 

INSERT WATER SPOUT

 

Insert the water supply unit

 

The "Crane" button is pressed, and the water supply unit is not inserted.

 

Insert the hot water supply.

 

INSERT INFUSER ASSEMBLY

 

Insert the infusion block

 

The brewing unit after cleaning may not be inserted in the coffee machine.

 

Insert the infusion block until it stops.

LESS COFFEE

 

Reducing the dose of coffee

 

Funnel for ground coffee is clogged.

 

Used too much coffee in grains or ground.

 

Empty the funnel with a long thin object (not sharp).

 

Choose a less strong coffee or reduce the amount of ground coffee and then turn on the coffee again

 

GENERIC ALARM

 

General alarm system

 

The coffee machine inside is very dirty.

 

Thoroughly clean the inside of the espresso machine. If, after cleaning, the coffee machine continues to display the message, contact the service center